Chapter 7 Setup Wizard
NWA/WAC/WAX Series User’s Guide
85
7.2.3.1 Edit SSID Profile
Use this screen to configure an SSID profile.
The screen varies depending on the security type you selected.
• SSID: Enter a descriptive name of up to 32 printable characters for the wireless LAN.
• Status: Select Active to apply this SSID profile on all the radios. Select Inactive to create the SSID profile
without applying this SSID on any radio.
• VLAN ID: Enter a VLAN ID for the Zyxel Device to use to tag traffic originating from this SSID.
• Band Mode: Select the WiFi band which this profile should use. 2.4 GHz is the frequency used by IEEE
802.11b/g/n WiFi clients. 5 GHz is the frequency used by IEEE 802.11ac/a/n WiFi clients. 6 GHz is the
frequency used by IEEE 802.11ax WiFi clients.
• Security Type: Select WPA2 or WPA3 to add security on this WiFi network. Otherwise, select OPEN or
Enhanced-Open to allow any WiFi client to associate this network without authentication.
• Personal: If you set Security Type to WPA2 or WPA3 and select Personal, enter a pre-shared key of
between 8 and 63 case-sensitive ASCII characters (including spaces and symbols) or 64 hexadecimal
characters.
• Enterprise: Select this option and the Primary / Secondary RADIUS Server check box to have the Zyxel
Device use the specified RADIUS server. You have to enter the IP address, port number and shared
secret password of the RADIUS server to be used for authentication.
Note: See Section 1.2 on page 14 for models that support the 6 GHz band.
Click OK to proceed. Click Cancel to close the screen without saving.
Figure 46 Wizard: SSID: Edit (WPA3-Personal)
To Next Page
Loading...
