Chapter 6 Monitor
WAH7601 User’s Guide
36
Figure 14 Log
6.3 DHCP Table
DHCP (Dynamic Host Configuration Protocol, RFC 2131 and RFC 2132) allows individual clients to obtain
TCP/IP configuration at start-up from a server. You can configure the WAH7601’s LAN as a DHCP server
or disable it. When configured as a server, the WAH7601 provides the TCP/IP configuration for the clients.
If DHCP service is disabled, you must have another DHCP server on that network, or else the device must
be manually configured.
Click Monitor > DHCP Table. Read-only information here relates to your DHCP status. The DHCP table
shows current DHCP client information (including MAC Address, and IP Address) of all network clients
using the WAH7601’s DHCP server.
Figure 15 Monitor > DHCP Table
The following table describes the labels in this screen.
Table 5 Monitor > DHCP Table
LABEL DESCRIPTION
# This is the index number of the host device.
Host Name This field displays the device host name.
IP Address This field displays the IP address relative to the # field listed above.
To Next Page
Loading...
