ZyXEL Communications WAH7601 - 9.3 IPv4;IPv6 Firewall Entries

Chapter 9 Firewall
WAH7601 User’s Guide
59
Figure 39 Configuration > Security > Firewall > Configure
The following table describes the labels in this screen.
9.3 IPv4/IPv6 Firewall Entries
The WAH7601 firewall is a packet filtering firewall and restricts access based on the source/destination
device network address of a packet and the type of application. Use this screen to configure firewall
rules. To access these screens, click Configuration > Firewall > IPv4 Firewall Entries or Configuration >
Firewall > IPv6 Firewall Entries.
Figure 40 Configuration > Security > Firewall > IPv4 Firewall Entries
Table 20 Configuration > Security > Firewall > Configure
LABEL DESCRIPTION
Firewall Enable Select Enable to activate the firewall. The WAH7601 performs access control when the firewall
is activated.
Packets Allowed Select Accept to allow access to the firewall rule in the list and block access to the ones that
do not match.
Select Drop to block access to the firewall rule in the list and allow access to the ones that do
not match.
Apply Click Apply to save the settings.