Chapter 7 Wireless
WX Series User’s Guide
107
Enter the MAC addresses of the WiFi devices that are allowed or denied access to the WX Device in
these address fields. Enter the MAC addresses in a valid MAC address format, that is, six hexadecimal
character pairs, for example, 12:34:56:78:9a:bc.
Figure 46 Network Setting> Wireless > MAC Authentication > Add/Edit
7.5 WPS Settings
WiFi Protected Setup (WPS) allows you to quickly set up a WiFi network with strong security, without
having to configure security settings manually. To set up a WPS connection between two devices, both
devices must support WPS. It is recommended to use the Push Button Configuration (PBC) method if your
WiFi client supports it. See Section 7.11.8.3 on page 124 for more information about WPS.
Note: The WX Device applies the security settings of the main SSID (SSID1) profile (see Section
7.2 on page 98).
Note: The WPS switch is grayed out when WiFi is disabled.
Click Network Setting > Wireless > WPS. The following screen displays. Click this switch and makes it turn
blue. Click Apply to activate the WPS function. Then you can configure the WPS settings in this screen.
To Next Page
Loading...
