ZyXEL Communications WX5600-T0 - Chapter 2: Hardware; 2.1 LEDs

WX Series User’s Guide
22
CHAPTER 2
Hardware
2.1 LEDs
Use the LEDs to determine if the WX Device is behaving normally or if there are problems on your
network.
See Table 4 on page 22 and Table 5 on page 23 for more information on the LEDs.
Figure 14 WX5600-T0 / WX3100-T0’s Front Panel
The following table describes the LED behaviors of WX3401, WX3100 and WX5600. None of the LEDs are
on if the WX Device is not receiving power.
Table 4 LED Table (for WX Device-1)
LED COLOR STATUS DESCRIPTION
POWER Green On Power is on or MPro Mesh pairing is done.
Blinking The WX Device is starting up or the MPro Mesh pairing is in
process.
Red On The WX Device detects a system error.
Blinking The WX Device is upgrading firmware or the MPro Mesh pairing
has failed.