Chapter 13 User Account
WX Series User’s Guide
148
13.2.1 User Account Add/Edit
Click Add New Account or the Edit icon of an existing account in the Maintenance > User Account to
open the following screen.
Figure 75 Maintenance > User Account > Add/Edit
The following table describes the labels in this screen.
Idle Timeout This field displays the length of inactive time before the WX Device will automatically log the user
out of the Web Configurator.
Lock Period This field displays the length of time a user must wait before attempting to log in again after a
number if consecutive wrong passwords have been entered as defined in Retry Times.
Group This field displays whether this user has Administrator or User privileges.
Modify Click the Edit icon to configure the entry.
Click the Delete icon to remove the entry.
Cancel Click Cancel to restore the default or previously saved settings.
Apply Click Apply to save your changes.
Table 43 Maintenance > User Account (continued)
LABEL DESCRIPTION
Table 44 Maintenance > User Account > Add/Edit
LABEL DESCRIPTION
Active Select Enable or Disable to activate or deactivate the user account.
User Name Enter a new name for the account. The User Name must contain 1 to 15 characters, including 0
to 9, a to z, and !@#%*()-_+=~,.{}[]\. Spaces are not allowed.
Password Type your new system password. The Password must contain 6 to 64 characters, including 0 to 9
and a to z. Note that as you type a password, the screen displays a (*) for each character you
type. After you change the password, use the new password to access the WX Device.
Verify Password Type the new password again for confirmation.
To Next Page
Loading...
