Chapter 2 Hardware
WX Series User’s Guide
26
Figure 17 WX5610-B0 Rear Panel
The following table describes the WX Device panel ports and buttons.
2.3 Wall Mounting
Do the following to attach your WX Device to a wall.
2.3.1 WX5600-T0 / WX3100-T0 Wall-Mounting
You may need screw anchors if mounting on a concrete or brick wall.
Table 7 Panel Ports and Buttons
LABEL DESCRIPTION
LAN1/LAN2/1G LAN/2.5G
LAN
Connect computers or other Ethernet devices to Ethernet ports for Internet access.
WPS Press the WPS button once for 1 to 3 seconds to enable the AP/Repeater mode. (See
Section 2.4.1 on page 28 for more information)
POWER ON/OFF or DC-IN Connect the power cable and then press the power button to start the device.
RESET Press the button to return the WX Device to the factory defaults.
To Next Page
Loading...
