Chapter 5 Connection Status
WX Series User’s Guide
81
5.4 LAN Settings
Use this screen to view the WX Device LAN IP address and subnet mask.
Figure 38 LAN
Click the Arrow icon ( ) to open the following screen. Use this screen to configure the WX Device LAN
IP address and subnet mask.
Figure 39 LAN Setup
Each field is described in the following table.
Table 17 Status Screen
LABEL DESCRIPTION
LAN IP Setup
IP Address Enter the LAN IPv4 address you want to assign to your WX Device in dotted decimal
notation, for example, 192.168.1.2 (factory default).
Subnet Mask Enter the subnet mask of your network in dotted decimal notation, for example
255.255.255.0 (factory default). Your WX Device automatically computes the subnet mask
based on the IP address you enter, so do not change this field unless you are instructed to
do so.
Save Click Save to save your changes.
To Next Page
Loading...
