Chapter 4 App Tutorials
WX Series User’s Guide
43
12 The POWER LED shows if the WX Device is ready to join the WiFi network. The LINK LED shows the WiFi link
quality. See Section Table 12 on page 43 for more information on LED behaviors.
Zyxel MPro Mesh router
4.3.2 Setting up the WX Device with a Non-MPro Mesh Router
This scenario describes the process to create a Mesh network with a wired connection from the non-
MPro Mesh router to the first WX Device (WX Device-1). This section uses a non-MPro Mesh router, the
WX3401-1, and WX3401-2 as an example.
Make sure the non-MPro Mesh router is connected to the Internet. The first WX Device (WX Device-1)
must be connected to your router using an Ethernet cable. Then, connect the second WX Device (WX
Device-2) wirelessly to the first WX Device (WX Device-1).
Follow the steps below to set up the WX Device-1 with a non-MPro Mesh router.
Table 12 LED Table (for WX Device-1)
LED COLOR STATUS DESCRIPTION
POWER Green On Power is on or the MPro Mesh configuration process is done.
Blinking The WX Device is starting up or under the MPro Mesh configuration process.
Red On The WX Device detects a system error.
Blinking The WX Device is upgrading firmware.
Link (With a
WiFi
connection)
Green On The WiFi connection to the MPro Mesh router is good.
Red On The signal is too weak. Move the WX Device closer to the MPro Mesh router.
To Next Page
Loading...
