Chapter 2 Hardware
WX Series User’s Guide
28
Figure 20 Wall Mounting
2.4 WPS Button
Your WX Device supports WiFi Protected Setup (WPS), which is an easy way to set up a secure WiFi
network. WPS is an industry standard specification, defined by the Wi-Fi Alliance.
WPS allows you to quickly set up a WiFi network with strong security, without having to configure security
settings manually. Each WPS connection works between two devices. Both devices must support WPS
(check each device’s documentation to make sure).
Depending on the devices you have, you can either press a button (recommended) on the device
itself, or in its Web Configurator. When WPS is activated on a device, it has 2 minutes to find another
device that also has WPS activated. Then, the two devices connect and set up a secure network by
themselves.
The WPS button is located at the front panel of the WX Device.
2.4.1 Using the WPS Button
1 Make sure the power LED is on (not blinking).
2 Choose a mode
•APC mode
1. Press the WX Device WPS button just once for 1 to 3 seconds. The WPS LED should start blinking.
2. Press the WPS button on the client within 2 minutes.
• AP Mode (Downlink Daisy Chain For MPro Mesh)
1. Press the first WX Device WPS button just once for 1 to 3 seconds.
2. Press the WPS button once on the downlink WX Device within 2 minutes.
To Next Page
Loading...
