Chapter 1 Introduction
WX Series User’s Guide
17
The following table describes the icons used in the figure.
Note: Your router must have an Internet connection whether it supports MPro Mesh or not.
Note: If your router supports Zyxel MPro Mesh, it will serve as the router controller in a Mesh
network with the WX Device.
Note: If your router does not support Zyxel MPro Mesh, your WX Device will automatically
become the AP controller.
1.3 Dual-Band WiFi
When WiFi is enabled on the WX Device, IEEE 802.11a/b/g/n/ac/ax compliant clients, such as
notebooks, tablets and smartphones can wirelessly connect to the WX Device to access network
resources.
With dual-band, the WX Device is a gateway that can use both 2.4 GHz and 5 GHz WiFi networks at the
same time. WiFi clients could use the 2.4 GHz band for regular Internet surfing and downloading while
using the 5 GHz band for time sensitive traffic like high-definition video, music, and gaming.
Go to Table 1 on page 12 to see if your WX Device supports dual-band WiFi.
Table 3 Icons Used in Mesh Application
ICON DESCRIPTION
C Router Controller (the DX5301-B0 in Scenario 1, see Section 4.3.1 on page 38) or AP controller
(the first WX Device in Scenario 2, see Section 4.3.2 on page 43)
AP Access Point
RP Repeater
C1 Client1
C2 Client2
APC Access Point coverage area
RPC Repeater coverage area
To Next Page
Loading...
