ZyXEL Communications ZyWALL 310 - How to Setup and Send Logs to a Syslog Server

179/255
www.zyxel.com
How to setup and send logs to a Syslog Server
This example shows how to set up the syslog server profiles to mail ZyWALL/USG log
messages to the specific destinations. You can also specify which log messages to
syslog server. When the syslog server is configured, you will receive the real time
system logs.
Figure 268 ZyWALL/USG Setup and Configure sending logs to a syslog and
Vantage Reports Server
Note: All network IP addresses and subnet masks are used as examples in this
article. Please replace them with your actual network IP addresses and subnet
masks. This example was tested using USG110 (Firmware Version: ZLD 4.15).