ZyXEL Communications ZyWALL 310 - Set up the NAT Router (Using Zywall USG Device in this Example)

50/255
www.zyxel.com
Set Up the NAT Router (Using ZyWALL USG device in this
example)
Go to CONFIGURATION > Network > NAT > Add. Select the Incoming Interface
on which packets for the NAT rule must be received. Specified
the User-Defined Original IP field and Type the translated destination IP address
that this NAT rule supports.
Figure 76 CONFIGURATION > Network > NAT > Add
Go to CONFIGURATION > Object > Address > Add, create an address object as the
ZyWALL/USU_HQ’s WAN IP address (in the example, 192.168.1.33).