70/255
How to redirect multiple LAN interface traffic to the VPN tunnel
This example shows how to use the VPN Setup Wizard to create a site-to-site VPN
with multiple LAN access to the VPN tunnel. The example instructs how to
configure the VPN tunnel between each site and redirect multiple LAN
interface traffic to the VPN tunnel. When the VPN tunnel is configured, multiple
LAN subnets can be accessed securely.
Figure 109 ZyWALL Site-to-site IPSec VPN with multiple LAN access
Note: All network IP addresses and subnet masks are used as examples in this
article. Please replace them with your actual network IP addresses and subnet
masks. This example was tested using USG310 (Firmware Version: ZLD 4.15).
To Next Page
Loading...
