91/255
Figure 147 Quick Setup > VPN Setup Wizard > Welcome > Wizard Type > VPN Settings >
Wizard Completed
Go to CONFIGURATION > VPN > IPSec VPN > VPN Gateway and click Show
Advanced Settings. Configure Authentication > Peer ID Type as Any to let the
ZyWALL/USG does not require to check the identity content of the remote IPSec
router.
Figure 148 CONFIGURATION > VPN > IPSec VPN > VPN Gateway > Show
Advanced Settings > Authentication > Peer ID Type
Go to Configuration > VPN > IPSec VPN > VPN Gateway > Gateway Settings. Set
My Address to be Domain Name/IP “0.0.0.0” (ZyWALL/USG will dial-up with the
active WAN interface first). Set Peer Gateway Address > Static Address >
Primary to be ZyWALL/USG_HQ WAN1 IP address and Secondary to be
ZyWALL/USG_HQ WAN2 IP address.
To Next Page
Loading...
