ZyXEL Communications ZyWALL Series - Page 133

Chapter 16 Interfaces
ZyWALL Series CLI Reference Guide
133
[no] first-wins-server
ip
Specifies the first WINS server IP address to assign to the remote users. The no
command removes the setting.
[no] second-wins-
server ip
Specifies the second WINS server IP address to assign to the remote users.
The no command removes the setting.
[no] lease {<0..365>
[<0..23> [<0..59>]] |
infinite}
Sets the lease time to the specified number of days, hours, and minutes or
makes the lease time infinite. The
no command resets the first DNS server
setting to its default value.
(no) bootp-server
<w.x.y.z>
Sets the PXE (Preboot eXecution Environment) server public IPv4 address.
PXE is available for computers on internal interfaces to allow them to boot
up using boot software on a PXE server. The Zyxel Device acts as an
intermediary between the PXE server and the computers that need boot
software.
You must enable DHCP Server on the Zyxel Device so that it can receive
information from the PXE server.
(no) bootfile-name
<filename>
Sets the file name and extension of the boot loader software file (a
computer program that loads the operating system for the computer) that
is on the PXE server. If the wrong filename is typed, then the client
computers cannot boot.
interface interface_name
Enters sub-command mode.
[no] ip dhcp-pool
profile_name
Binds the specified interface to the specified DHCP pool. You have to
remove any DHCP relays first. The
no command removes the binding.
[no] ip helper-address
ip
Creates the specified DHCP relay. You have to remove the DHCP pool first,
if the DHCP pool is bound to the specified interface. The
no command
removes the specified DHCP relay.
release dhcp interface-
name
Releases the TCP/IP configuration of the specified interface. The interface
must be a DHCP client. This command is available in privilege mode, not
configuration mode.
renew dhcp interface-name
Renews the TCP/IP configuration of the specified interface. The interface
must be a DHCP client. This command is available in privilege mode, not
configuration mode.
show ip dhcp binding [ip]
Displays information about DHCP bindings for the specified IP address or for
all IP addresses.
clear ip dhcp binding {ip |
*}
Removes the DHCP bindings for the specified IP address or for all IP
addresses.
Table 56 interface Commands: DHCP Settings (continued)
COMMAND DESCRIPTION