ZyXEL Communications ZyWALL Series - 63.9 Language Commands; 63.10 IPv6 Commands; 63.11 ZON Overview

Chapter 63 System
ZyWALL Series CLI Reference Guide
525
63.9 Language Commands
Use the language commands to display what language the web configurator is using or change it. You
must use the
configure terminal command to enter the configuration mode before you can use
these commands.
63.10 IPv6 Commands
Use the ipv6 commands to enable or disable IPv6 support. You must use the configure terminal
command to enter the configuration mode before you can use the commands that configure settings.
63.11 ZON Overview
The Zyxel One Network (ZON) utility uses the Zyxel Discovery Protocol (ZDP) for discovering and
configuring ZDP-aware Zyxel devices in the same broadcast domain as the computer on which ZON is
installed.
Table 301 Command Summary: Language
COMMAND DESCRIPTION
language language_name
Specifies the language used in the web configurator screens.
To view a list of supported language names, run the command
show
language all.
[no] language update auto
Enables (disables) automatic language pack updates at regular times and
days.
Note: To save network resources, periodically run the “language
update package” command instead of enabling
automatic updates.
language update daily
<0..23>
Enables automatic language pack updates every day at the time
specified.
language update hourly
Enables automatic language pack updates every hour.
language update package
Immediately updates the language pack from the update server.
language update weekly {sun
| mon | tue | wed | thu |
fri | sat} <0..23>
Enables automatic language pack updates once-a-week at the time and
day specified.
show language {setting |
all}
setting displays the current display language in the web configurator
screens.
all displays the languages available on the Zyxel Device.
Table 302 Command Summary: IPv6
COMMAND DESCRIPTION
[no] ipv6 activate
Enables or disables IPv6 support.
show ipv6 status
Displays whether IPv6 support is enabled or disabled.