ZyXEL Communications ZyWALL Series - 20.2 Zone Commands Summary

Chapter 20 Zones
ZyWALL Series CLI Reference Guide
187
20.2 Zone Commands Summary
The following table describes the values required for many zone commands. Other values are discussed
with the corresponding commands.
This table lists the zone commands.
Table 93 Input Values for Zone Commands
LABEL DESCRIPTION
profile_name
The name of a zone, or the name of a VPN tunnel.
For some Zyxel Device models, use up to 31 characters (a-zA-Z0-9_-). The name cannot start
with a number. This value is case-sensitive.
For other Zyxel Devicemodels:
• The lan1 interface always belongs to the LAN1 zone.
• The lan2 interface always belongs to the LAN2 zone.
• The dmz interface always belongs to the DMZ zone.
• The wan1, wan2, wan1_ppp, or wan2_ppp interfaces always belong to the WAN zone.
• An opt_ppp interface can be added to the WAN or OPT zone.
Table 94 zone Commands
COMMAND DESCRIPTION
show zone
[profile_name]
Displays information about the specified zone or about all zones.
show zone binding-
iface
Displays each interface and zone mappings.
show zone default-
binding
Displays the pre-configured interface and zone mappings that come with the
Zyxel Device.
show zone none-binding
Displays the interfaces, tunnels and SSL VPNs that are not associated with a zone
yet.
show zone system-
default
Displays the pre-configured default zones that you cannot delete from the Zyxel
Device.
show zone user-define
Displays all customized zones.
[no] zone profile_name
Creates the zone if necessary and enters sub-command mode. The no
command deletes the zone.
zone profile_name
Enter the sub-command mode.
[no] interface
interface_name
Adds the specified interface to the specified zone. The no command removes
the specified interface from the specified zone. See Section 16.2 on page 121 for
information about interface names.
[no] crypto
profile_name
Adds the specified IPSec VPN tunnel to the specified zone. The no command
removes the specified IPSec VPN tunnel from the specified zone.
[no] sslvpn
profile_name
Adds the specified SSL VPN tunnel to the specified zone. The no command
removes the specified SSL VPN tunnel from the specified zone.