Chapter 18 Route
ZyWALL Series CLI Reference Guide
176
interface ge1 to the next-hop router GW_1. This route uses the IP address of the outgoing interface as
the matched packets’ source IP address.
18.3 IP Static Route
The Zyxel Device has no knowledge of the networks beyond the network that is directly connected to
the Zyxel Device. For instance, the Zyxel Device knows about network N2 in the following figure through
gateway R1. However, the Zyxel Device is unable to route a packet to network N3 because it doesn't
know that there is a route through the same gateway R1 (via gateway R2). The static routes are for you
to tell the Zyxel Device about the networks beyond the network connected to the Zyxel Device directly.
Router(config)# address-object TW_SUBNET 192.168.2.0 255.255.255.0
Router(config)# address-object GW_1 192.168.2.250
Router(config)# policy insert 1
Router(policy-route)# description example
Router(policy-route)# destination any
Router(policy-route)# interface ge1
Router(policy-route)# next-hop gateway GW_1
Router(policy-route)# snat outgoing-interface
Router(policy-route)# source TW_SUBNET
Router(policy-route)# exit
Router(config)# show policy-route 1
index: 1
active: yes
auto-disable: no
description: example
user: any
schedule: none
interface: ge1
tunnel: none
sslvpn: none
source: TW_SUBNET
destination: any
DSCP code: any
service: any
srcport: any
nexthop type: Gateway
nexthop: GW_1
nexthop state: Not support
auto destination: no
SNAT: outgoing-interface
DSCP marking: preserve
connectivity-check: no
Router(config)#
To Next Page
Loading...
