Chapter 52 Addresses
ZyWALL Series CLI Reference Guide
466
52.2.4 Geo IP
Use these commands to update the database of country-to-IP address mappings and manually
configure custom country-to-IP address mappings in geographic address objects. You can then use
geographic address objects in security policies to forward or deny traffic to whole countries or regions.
Note: You need to have a registered Content Filter 2.0 Service license to use the country-to-IP
and continent-to-IP address database.
52.2.5 FQDN / Geo IP Commands
You must be in configuration mode (configure terminal) to use the indented commands shown
below.
Table 262 FQDN / Geo IP Commands
COMMAND DESCRIPTION
[no] geo-ip database update
auto
Enables the Zyxel Device to automatically check for the latest country-
to-IP-address database version on myZyxel.com and allows it to be
automatically updated when there is newer version available.
The no command disallows the Zyxel Device automatically checking
for the latest country-to-IP-address database version on myZyxel.com.
geo-ip database update
country
Updates the country-to-IP-address database for all countries.
geo-ip database update weekly
{fri | mon | sat | sun | thu |
tue | wed} <0..23>
Specifies the weekly day and time the Zyxel Device should check for
the latest country-to-IP-address database version on myZyxel.com if
automatic checking is enabled.
geo-ip [no] geography
<country_code> all address
{ipv4 | ip6}
Creates a new geography-to-IP-address mapping for the specified
country. Use show geo-ip country-code
to see the 2-letter
abbreviation for each country.
The no command removes the new geography-to-IP-address mapping
for the specified country.
show geo-ip database update
Shows if the country-to-IP address database is automatically updated
and the schedule.
show geo-ip database version
Shows the latest and current country-to-IP-address database version.
show geo-ip database version
country
Shows the latest and current country-to-IP-address database version.
show geo-ip country-code
Shows the 2-letter abbreviation for each country.
show geo-ip country-list
region code
Shows the countries that belong to the continent.
show geo-ip region-code
Shows the 2-letter abbreviation for each continent.
show geo-ip geography
Shows customized country-to-IPv4-address mappings.
show geo-ip geography6
Shows customized country-to-IPv6-address mappings.
To Next Page
Loading...
