ZyXEL Communications ZyWALL Series - 40.3.2 URL Threat Filter Profile Commands

Chapter 40 Reputation Filter
ZyWALL Series CLI Reference Guide
335
2 Enable URL threat filter trust list.
3 Enter the sub-command mode. Configure the URL threat filter trust list as the parameters given above.
4 Save the current configuration to the Zyxel Device.
40.3.2 URL Threat Filter Profile Commands
On Zyxel Devices that do not support multiple URL threat filter profiles, edit the profile named
default_profile to change settings in the Web Configurator UI.
Router# configure terminal
Router(config)# security-service anti-botnet-url activate
Router(config)# threat-website action block
Router(config)# anti-botnet log alert
Router(config)# threat-website block message Access to this website is not allowed.
Router(config)# threat-website category browser-exploits
Router(config)# threat-website category malicious-downloads
Router(config)# threat-website category malicious-sites
Router(config)# threat-website category phishing
Router(config)# threat-website category spam-urls
Router(config)# threat-website trust-list activate
Router(config)# threat-website trust
Router(Host)# www.google.com
Router(Host)# www.yahoo.com
Router(Host)# exit
Router(config)# write
Table 182 URL Threat Filter Profile Commands
COMMAND DESCRIPTION
threat-website rename
old_profile_name
new_profile_name
Renames the URL Threat Filter profile.
threat-website profile
profile_name
Creates the specified URL Threat Filter profile, if it does not already exist.