ZyXEL Communications ZyWALL Series - 32.11 IPnP Commands Example; 32.12 Walled Garden Overview; 32.13 Walled Garden Commands

Chapter 32 Hotspot
ZyWALL Series CLI Reference Guide
272
32.11 IPnP Commands Example
The following example enables IPnP on the Zyxel Device and interface lan1. It also displays the IPnP
settings.
32.12 Walled Garden Overview
A user must log in before the Zyxel Device allows the user’s access to the Internet. However, with a
walled garden, you can define one or more web site addresses that all users can access without
logging in. These can be used for advertisements for example.
32.13 Walled Garden Commands
This table lists the walled-garden commands. You must use the configure terminal command to
enter the configuration mode before you can use these commands.
show ip ipnp activation
Displays whether IPnP is enabled on the Zyxel Device.
show ip ipnp interface
Displays whether IPnP is enabled on an interface.
Table 141 ipnp Commands (continued)
COMMAND DESCRIPTION
Router# configure terminal
Router(config)# ip ipnp activate
Router(config)# ip ipnp config
Router(ipnp)# interface lan1
Router(ipnp)# exit
Router(config)# show ip ipnp activation
IPnP Status: yes
Router(config)# show ip ipnp interface
interface
===============================================================================
lan1
Router(config)#
Table 142 walled-garden Commands
COMMAND DESCRIPTION
[no] walled-garden activate
Enables the walled garden feature. The no command disables the walled
garden feature.
[no] walled-garden rule <1..50>
Creates a walled garden URL link entry (URLs that use the HTTP or HTTPS
protocol) for web site that all users are allowed to access without logging in,
and enters sub-command mode. See Section Table 143 on page 273 for the
rule sub-commands.
walled-garden rule append
Creates a new walled garden URL entry at the end of the current list and enters
sub-command mode. See Table 143 on page 273 for the sub-commands.