Chapter 16 Interfaces
ZyWALL Series CLI Reference Guide
142
The following commands set port 1 to use auto-negotiation auto and port 2 to use a 10 Mbps
connection speed and half duplex.
16.4 Virtual Interface Specific Commands
Virtual interfaces use many of the general interface commands discussed at the beginning of Section
16.2 on page 121. There are no additional commands for virtual interfaces.
16.4.1 Virtual Interface Command Examples
The following commands set up a virtual interface on top of Ethernet interface ge1. The virtual interface
is named ge1:1 with the following parameters: IP 1.2.3.4, subnet 255.255.255.0, gateway 4.6.7.8,
upstream bandwidth 345, downstream bandwidth 123, and description “I am vir interface”.
16.5 PPPoE/PPTP Specific Commands
This section covers commands that are specific to PPPoE/PPTP interfaces. PPPoE/PPTP interfaces also use
many of the general interface commands discussed at the beginning of Section 16.2 on page 121.
The following table identifies the values required for many of these commands. Other input values are
discussed with the corresponding commands.
Router(config)# port status Port1
Router(config-port-status)# negotiation auto
Router(config-port-status)# exit
Router(config)# port status Port2
Router(config-port-status)# duplex half
Router(config-port-status)# speed 10
Router(config-port-status)# exit
Router(config)# exit
Router# configure terminal
Router(config)# interface ge1:1
Router(config-if-vir)# ip address 1.2.3.4 255.255.255.0
Router(config-if-vir)# ip gateway 4.6.7.8
Router(config-if-vir)# upstream 345
Router(config-if-vir)# downstream 123
Router(config-if-vir)# description I am vir interface
Router(config-if-vir)# exit
Table 64 Input Values for PPPoE/PPTP Interface Commands
LABEL DESCRIPTION
interface_name
PPPoE/PPTP interface: pppx, x = 0 - N, where N depends on the number of PPPoE/PPTP
interfaces your Zyxel Device model supports.
profile_name
The name of the ISP account. You may use 1-31 alphanumeric characters, underscores(_),
or dashes (-), but the first character cannot be a number. This value is case-sensitive.
To Next Page
Loading...
