Chapter 16 Interfaces
ZyWALL Series CLI Reference Guide
149
16.6.2 Cellular Interface Command Examples
This example shows the configuration of a cellular interface named cellular2 for use with a Sierra Wireless
AC850 3G card. It uses only a 3G (or 3.5G) connection, PIN code 1234, an MTU of 1200 bytes, a
description of "This is cellular2” and sets the connection to be nailed-up.
This second example shows specifying a new PIN code of 4567.
This example shows the 3G and SIM card information for interface cellular2 on the Zyxel Device.
Router(config)# interface cellular2
Router(config-if-cellular)# device AC850
Router(config-if-cellular)# band wcdma
Router(config-if-cellular)# pin 1234
Router(config-if-cellular)# connectivity nail-up
Router(config-if-cellular)# description This is cellular2
Router(config-if-cellular)# mtu 1200
Router(config-if-cellular)# exit
Router(config)# interface cellular2
Router(config-if-cellular)# pin 4567
Router(config-if-cellular)# exit
Router(config)# show interface cellular2 device status
interface name: cellular2
extension slot: USB 1
service provider: Chunghwa Telecom
cellular system: WCDMA
signal strength: -95 dBm
signal quality: Poor
device type: WCDMA
device manufacturer: Huawei
device model: E220/E270/E800A
device firmware: 076.11.07.106
device IMEI/ESN: 351827019784694
SIM card IMSI: 466923100565274
To Next Page
Loading...
