ZyXEL Communications ZyWALL Series - Page 159

Chapter 16 Interfaces
ZyWALL Series CLI Reference Guide
159
arp {arp-interval
<1..1000> | arp-ip-
target <W.X.Y.Z>}
Configure for arp Link Monitoring.
arp-interval: Specifies the frequency of ARP requests sent to confirm a
that slave interface is up.
arp-ip-target <W.X.Y.Z>: Specifies the IP address of the link to send ARP
queries.
miimon <1..1000>
Configure for mii Link Monitoring.
Specifies the link check interval in milliseconds that the system polls the
Media Independent Interface (MII) to get status.
xmit-hash-policy
{layer2 | layer2_3}
Configure for 802.3ad Mode.
Specifies the algorithm for slave selection according to the selected TCP/IP
layer.
lacp-rate {fast |
slow}
Configure for 802.3ad Mode.
Specifies the preferred LACPDU packet transmission rate (fast | slow) to
request from 802.3ad partner.
updelay <0..1000>
Configure for mii Link Monitoring.
Specifies the waiting time in milliseconds to confirm the slave interface status
is up.
downdelay <0..1000>
Configure for mii Link Monitoring.
Specifies the waiting time in milliseconds to confirm the slave interface status
is down.
igmp {activate |
direction {downstream
| upstream} | version
<1..3>}
See Table 54 on page 128 for these command descriptions.
ping-check
See Table 60 on page 138 for these command descriptions.
type {external |
general | internal}
Specifies one of the following option depending on the type of network to
which the Zyxel Device is connected or if you want to additionally manually
configure some related settings.
internal is for connecting to a local network. Other corresponding
configuration options: DHCP server and DHCP relay. The Zyxel Device
automatically adds default SNAT settings for traffic flowing from this interface
to an external interface.
external is for connecting to an external network (like the Internet). The
Zyxel Device automatically adds this interface to the default WAN trunk.
For general, the rest of the screen’s options do not automatically adjust and
you must manually configure a policy route to add routing and SNAT settings
for the interface.
show lag available slaves
Displays the available slaves that could be added to a LAG.
show interface lag
Displays interface details for all LAG interfaces.
show interface lagx
Displays interface details for LAG x.
Table 76 interface Commands: LAG Interfaces (continued)
COMMAND DESCRIPTION