Chapter 18 Route
ZyWALL Series CLI Reference Guide
174
[no] tunnel tunnel_name
Sets the incoming interface to an IPSec VPN tunnel. The no command
removes the IPSec VPN tunnel through which the incoming packets are
received.
[no] user user_name
Sets the user name. The no command resets the user name to the default
(any). any means all users.
[no] policy controll-ipsec-dynamic-
rules activate
Enables the Zyxel Device to use policy routes to manually specify the
destination addresses of dynamic IPSec rules. You must manually create
these policy routes. The Zyxel Device automatically obtains source and
destination addresses for dynamic IPSec rules that do not match any of
the policy routes.
The no command has the Zyxel Device automatically obtain source and
destination addresses for all dynamic IPSec rules.
policy default-route
Enters the policy-route sub-command mode to set a route with the name
“default-route”.
policy delete policy_number
Removes a routing policy.
policy flush
Clears the policy routing table.
policy list table
Displays all policy route settings.
policy move policy_number to
policy_number
Moves a routing policy to the number that you specified.
[no] policy override-direct-route
activate
Has the Zyxel Device forward packets that match a policy route
according to the policy route instead of sending the packets to a directly
connected network. Use the no command to disable it.
[no] policy controll-virtual-server-
rules activate
Gives policy routes priority over NAT virtual server rules (1-1 SNAT). Use the
no command to give NAT virtual server rules priority over policy routes.
[no] policy6 override-direct-route
activate
Has the Zyxel Device forward IPv6 packets that match a policy route
according to the policy route instead of sending the packets to a directly
connected network. Use the no command to disable it.
show bwm activation
Displays whether or not the global setting for bandwidth management on
the Zyxel Device is enabled.
show bwm-usage < [policy-route
policy_number] | [interface
interface_name]
Displays the specified policy route or interface’s bandwidth allotment,
current bandwidth usage, and bandwidth usage statistics.
show policy-route [policy_number]
Displays all or specified policy route settings.
show policy-route begin <1..200> end
<1..200>
Displays the specified range of policy route settings.
show policy-route conn-check
Displays the policy route for the connection check.
show policy-route conn-check
[policy_number]
Displays the specified policy route for the connection check.
show policy-route conn-check status
[policy_number]
Displays the connection check status for the specified policy route.
show policy-route controll-ipsec-
dynamic-rules
Displays whether the Zyxel Device checks policy routes first before IPSec
dynamic rules.
show policy-route override-direct-
route
Displays whether or not the Zyxel Device forwards packets that match a
policy route according to the policy route instead of sending the packets
to a directly connected network.
show policy-route controll-virtual-
server-rules
Displays whether or not policy routes have priority over NAT virtual server
rules (1-1 SNAT).
Table 82 Command Summary: Policy Route (continued)
COMMAND DESCRIPTION
To Next Page
Loading...
