Chapter 71 Maintenance Tools
ZyWALL Series CLI Reference Guide
595
conf-mail send-now <configfile>
Sends the specified configuration file to the configured email
addresses.
<CONFIGFILE> must contain a full file path, for example: /conf/
system-default.conf
show config-backup status
Shows the backup mail settings.
The conf-backup commands automatically backup the current Zyxel Device
configuration file according to a schedule, and then send it to an email address.
config-backup setting
Enters the configuration file scheduled backup subcommand
mode.
mail-attach password
<attachment password>
Adds an encryption password to the configuration file in the
email.
The password must consist of 1–31 ASCII characters.
no mail-attach password
Removes the encryption password from the email.
mail-info content <mail-
content>
Sets the backup email body text.
The text must consist of 1–250 ASCII characters.
no mail-info content
Clears the backup email body text.
mail-info {mail-to-1|mail-to-
2|mail-to-3|mail-to-4|mail-to-
5} <user@domainname>
Sets the receiving email address.
You can send the configuration file to a maximum of five email
addresses.
no {mail-to-1|mail-to-2|mail-
to-3|mail-to-4|mail-to-5}
Clears the receiving email address.
[no] mail-send
The Zyxel Device backs up the current configuration file, and
then sends it to the configured email addresses.
With the [no] option, the Zyxel Device only backs up the current
configuration file.
scheduler daily <time,hh:mm>
Sets the device to backup its config file once a day at the
specified hour and minute.
hh:mm is in 24-hour format, for example 23:30.
scheduler weekly <time,hh:mm>
{sun|mon|tue|wed|thu|fri|sat}
Sets the device to backup its config file once a week on the
specified day, at the specified hour and minute.
hh:mm is in 24-hour format, for example 23:30.
scheduler monthly <time,hh:mm>
<day,dd>
Sets the device to backup its config file once a month on the
specified day, at the specified hour and minute.
dd must be written as two digits. The valid range is 01–31. If the
day is greater than the number of days in the month, then the
job will run on the last day of the month.
exit
Exits subcommand mode.
[no] config-backup scheduler
activate
Enables or disables the automatic configuration file backup.
config-backup run
Backups up the configuration file now.
show config-backup status
Shows the schedules configuration file backup settings.
Table 341 Configuration File Backup Commands (continued)
COMMAND DESCRIPTION
To Next Page
Loading...
