Chapter 7 Built-in AP
ZyWALL Series CLI Reference Guide
71
[no] ap-mode detection
activate
Sets the built-in AP to detect Rogue APs in then network.
Use the no parameter to disable rogue AP detection.
For details about this feature, see Chapter 10 on page 100.
location location
Sets the name of the place where the AP is located, for admin
reference.
Use the no command to remove the specified setting.
[no] override slot_name
{output-power | radio-setting
| ssid-setting}
Sets the Zyxel Device to overwrite the built-in AP’s output power,
radio or SSID profile settings for the specified radio.
Use the no command to not overwrite the specified settings.
sysname system_name
Sets a name to identify the AP on a network. This is
usually the AP’s fully qualified domain name.
Use the no command to remove the specified setting.
exit
Exits sub-command mode.
COMMAND DESCRIPTION
To Next Page
Loading...
