Chapter 8 AP Group
ZyWALL Series CLI Reference Guide
74
[no] lan-provision model
{nwa5301-nj | wac6502d-e |
wac6502d-s | wac6503d-s |
wac6553d-e} ap_lan_port
inactivate pvid <1..4094>
Sets the model of the managed AP and disable the model-
specific LAN port and configure the port VLAN ID.
Use the no command to remove the specified port and VLAN
settings.
ap_lan_port: the Ethenet LAN port on the managed AP, such
as lan1 or lan2.
[no] lan-provision model
{nwa5301-nj | wac6502d-e |
wac6502d-s | wac6503d-s |
wac6553d-e} vlan_interface
activate vid <1..4094> join
ap_lan_port {tag | untag}
[ap_lan_port {tag | untag}]
[ap_lan_port {tag | untag}]
Sets the model of the managed AP, enable a VLAN and
configure the VLAN ID. It also sets the Ethernet port(s) on the
managed AP to be a member of the VLAN, and sets the port(s)
to send packets with or without a VLAN tag.
Use the no command to remove the specified port and VLAN
settings.
vlan_interface: the name of the VLAN, such as vlan0.
ap_lan_port: the Ethenet LAN port on the managed AP, such
as lan1 or lan2.
[no] lan-provision model
{nwa5301-nj | wac6502d-e |
wac6502d-s | wac6503d-s |
wac6553d-e} vlan_interface
inactivate vid <1..4094> join
ap_lan_port {tag | untag}
[ap_lan_port {tag | untag}]
[ap_lan_port {tag | untag}]
Sets the model of the managed AP, disable a VLAN and
configure the VLAN ID. It also sets the Ethernet port(s) on the
managed AP to be a member of the VLAN, and sets the port(s)
to send packets with or without a VLAN tag.
Use the no command to remove the specified port and VLAN
settings.
vlan_interface: the name of the VLAN, such as vlan0.
ap_lan_port: the Ethenet LAN port on the managed AP, such
as lan1 or lan2.
[no] load-balancing [slot1 |
slot2] activate
Enables load balancing. Use the no parameter to disable it.
Optionally specify a radio slot.
load-balancing [slot1 | slot2]
alpha <1..255>
Sets the load balancing alpha value.
When the AP is balanced, then this setting delays a client’s
association with it by this number of seconds.
Note: This parameter has been optimized for the Zyxel
Device and should not be changed unless you
have been specifically directed to do so by Zyxel
support.
load-balancing [slot1 | slot2]
beta <1..255>
Sets the load balancing beta value.
When the AP is overloaded, then this setting delays a client’s
association with it by this number of seconds.
Note: This parameter has been optimized for the Zyxel
Device and should not be changed unless you
have been specifically directed to do so by Zyxel
support.
load-balancing [slot1 | slot2]
kickInterval <1..255>
Enables the kickout feature for load balancing and also sets the
kickout interval in seconds. While load balancing is enabled, the
AP periodically disconnects stations at intervals equal to this
setting.
This occurs until the load balancing threshold is no longer
exceeded.
Table 19 Command Summary: AP Group (continued)
COMMAND DESCRIPTION
To Next Page
Loading...
