ZyXEL Communications ZyWALL Series - Page 77

Chapter 8 AP Group
ZyWALL Series CLI Reference Guide
77
The following example shows you how to create an AP group profile (named GP2) and configure AP
load balancing in "by traffic" mode. The traffic level is set to low, and "disassociate station" is enabled.
The following example shows the settings and status of the VLAN(s) configured for the managed APs
(NWA5301-NJ) in the default AP group.
Router(config)# ap-group-profile GP2
Router(config-ap-group GP2)# load-balancing mode traffic
Router(config-ap-group GP2)# load-balancing traffic level low
Router(config-ap-group GP2)# load-balancing kickout
Router(config-ap-group GP2)# exit
Router(config)# show ap-group-profile GP2 load-balancing config
AP Group Profile:GP2
load balancing config:
Activate: yes
Kickout: yes
Mode: traffic
Max-sta: 1
Traffic-level: low
Alpha: 5
Beta: 10
Sigma: 60
Timeout: 20
LIInterval: 10
KickoutInterval: 20
Router(config)#
Router(config)# show ap-group-profile default lan-provision interface vlan
model nwa5301-nj
No. Name Active VID Member
===========================================================================
1 vlan0 yes 1 lan1,lan2,lan3
Router(config)# show ap-group-profile default lan-provision interface vlan0
model nwa5301-nj
active: yes
interface name: vlan0
VID: 1
member: lan1&lan2&lan3
lan1_tag: untag
lan2_tag: untag
lan3_tag: untag
Router(config)#