Appendix A Log Descriptions
ZyWALL USG 300 User’s Guide
1007
System default ppp
interface can not be
removed.
A PPP interface could not be removed because it is a system
default PPP interface.
Interface property can
not change to internal
since interface is the
member of other trunk.
An interface can not be set to be an internal interface because
it is a member of a trunk.
Port-grouping is not
support
The interface does not support port grouping.
This interface type
can not set 3rd-dns.
This type of interface does not support setting a third DNS
server setting.
name=%s,status=%s,TxP
kts=%u,
RxPkts=%u,Colli.=%u,T
xB/s=%u,
RxB/s=%u,UpTime=%s
This log is sent to the VRPT server to show the specified PPP/
Cellular interface’s statistics and uptime.
The arguments represent the interface name, interface
status, interface Tx packets, interface Rx packets, interface
collision packets, interface Tx Bytes/s, interface Rx Bytes/s,
and interface up time.
Interface %s has been
renamed from '%s' to
'%s '
The user-configurable name of the specified interface
(internal system name) has been renamed from one name to
another.
Table 304 WLAN Logs
LOG MESSAGE DESCRIPTION
Wlan %s is enabled. The WLAN (IEEE 802.11 b and or g) feature has been turned
on. %s is the slot number where the WLAN card is or can be
installed.
Wlan %s is disabled. The WLAN (IEEE 802.11 b and or g) feature has been turned
off. %s is the slot number where the WLAN card is or can be
installed.
Wlan %s has been
configured.
The WLAN (IEEE 802.11 b and or g) feature’s configuration
has been changed. %s is the slot number where the WLAN
card is or can be installed.
Interface %s has been
configured.
The configuration of the specified WLAN interface (%s) has
been changed.
Interface %s has been
deleted.
The specified WLAN interface (%s) has been removed.
Create interface %s
has failed. Wlan
device does not exist.
The wireless device failed to create the specified WLAN
interface (%s). Remove the wireless device and reinstall it.
System internal error.
No 802.1X or WPA
enabled!
IEEE 802.1x or WPA is not enabled.
System internal error.
Error configuring WPA
state!
The ZyWALL was not able to configure the wireless device to
use WPA. Remove the wireless device and reinstall it.
Table 303 Interface Logs (continued)
LOG MESSAGE DESCRIPTION
To Next Page
Loading...
