ZyXEL Communications ZyWALL USG 300 - How to Configure a Cellular Interface

Chapter 7 Tutorials
ZyWALL USG 300 User’s Guide
120
2 Drag physical port 5 onto representative interface ge4 and click Apply.
Figure 63 Configuration > Network > Interface > Port Grouping Example
3 Click Dashboard, and look at the Interface Status Summary. Ethernet
interface ge4 has a status of Port Group Up if it is connected or Port Group
Down if it is not connected. Ethernet interfaces ge5 has a Status of Port Group
Inactive.
Figure 64 Dashboard: Interface Status Summary After Port Grouping
7.2 How to Configure a Cellular Interface
Use 3G cards for cellular WAN (Internet) connections. Table 275 on page 941 lists
the compatible 3G devices. In this example you install or connect the 3G card
before you configure the cellular interfaces but is also possible to reverse the
sequence.
1 Make sure the 3G device’s SIM card is installed.
2 Install the 3G device in the ZyWALL’s PCIMCIA slot or connect it to one of the
ZyWALL’s USB ports.