ZyXEL Communications ZyWALL USG 300 - Default Interface and Zone Configuration

Chapter 6 Configuration Basics
ZyWALL USG 300 User’s Guide
96
6.2.2 Default Interface and Zone Configuration
This section introduces the ZyWALL’s default zone member physical interfaces and
the default configuration of those interfaces. The following figure uses letters to
denote public IP addresses or part of a private IP address.
Figure 56 Default Network Topology
Table 14 Default Port, Interface, and Zone Configuration
• The LAN zone contains the ge1 interface. The LAN zone is a protected zone. The
ge1 interface uses 192.168.1.1.
PORT INTERFACE ZONE
IP ADDRESS AND DHCP
SETTINGS
SUGGESTED USE WITH
DEFAULT SETTINGS
1 ge1 LAN 192.168.1.1, DHCP server
enabled
Protected LAN
2, 3 ge2, ge3 WAN DHCP clients Connections to the Internet
4, 5 ge4, ge5 DMZ 192.168.2.1 (ge4) and
192.168.3.1 (ge5), DHCP
server disabled
Public servers (such as web,
e-mail and FTP)
6 ge6 WLAN 10.59.0.1, DHCP server
enabled
Wireless access points
7 ge7 None None, DHCP server
disabled
Optional
AUX aux None None Auxiliary modem
CONSOLE N/A None None Local management