ZyXEL Communications ZyWALL USG 300 - Base Profiles; Configuring the ADP Profile Summary Screen

Chapter 35 ADP
ZyWALL USG 300 User’s Guide
633
35.3.1 Base Profiles
The ZyWALL comes with base profiles. You use base profiles to create new
profiles. In the Configuration > Anti-X > ADP > Profile screen, click Add to
display the following screen.
Figure 445 Base Profiles
These are the default base profiles at the time of writing.
35.3.2 Configuring The ADP Profile Summary Screen
Select Configuration > Anti-X > ADP > Profile.
Figure 446 Configuration > Anti-X > ADP > Profile
Table 172 Base Profiles
BASE
PROFILE
DESCRIPTION
none All traffic anomaly and protocol anomaly rules are disabled. No logs are
generated nor actions are taken.
all All traffic anomaly and protocol anomaly rules are enabled. Rules with a
high or severe severity level (greater than three) generate log alerts
and cause packets that trigger them to be dropped. Rules with a very
low, low or medium severity level (less than or equal to three) generate
logs (not log alerts) and no action is taken on packets that trigger them.
OK Click OK to save your changes.
Cancel Click Cancel to exit this screen without saving your changes.