ZyXEL Communications ZyWALL USG 300 - PPP Interface Add or Edit

Chapter 13 Interfaces
ZyWALL USG 300 User’s Guide
313
13.4.2 PPP Interface Add or Edit
Note: You have to set up an ISP account before you create a PPPoE/PPTP interface.
This screen lets you configure a PPPoE or PPTP interface. To access this screen,
click the Add icon or an Edit icon in the PPP Interface screen.
Status The activate (light bulb) icon is lit when the entry is active and
dimmed when the entry is inactive.
The connect icon is lit when the interface is connected and dimmed
when it is disconnected.
Name This field displays the name of the interface.
Base Interface This field displays the interface on the top of which the PPPoE/PPTP
interface is.
Account Profile This field displays the ISP account used by this PPPoE/PPTP interface.
Apply Click Apply to save your changes back to the ZyWALL.
Reset Click Reset to return the screen to its last-saved settings.
Table 64 Configuration > Network > Interface > PPP (continued)
LABEL DESCRIPTION