Chapter 7 Tutorials
ZyWALL USG 300 User’s Guide
143
1 Click Configuration > Object > Address. Click the Add icon.
2 Give the new address object a name (“VPN_REMOTE_SUBNET”), change the
Address Type to SUBNET. Set up the Network field to 172.16.1.0 and the
Netmask to 255.255.255.0. Click OK.
Figure 98 Configuration > Object > Address > Add
3 Click Configuration > VPN > IPSec VPN > VPN Connection. Click the Add
icon.
4 Enable the VPN connection and name it (“VPN_CONN_EXAMPLE”). Under VPN
Gateway select Site-to-site and the VPN gateway (VPN_GW_EXAMPLE).
Under Policy, select LAN_SUBNET for the local network and
VPN_REMOTE_SUBNET for the remote. Click OK.
Figure 99 Configuration > VPN > IPSec VPN > VPN Connection > Add
5 Now set up the VPN settings on the peer IPSec router and try to establish the VPN
tunnel. To trigger the VPN, either try to connect to a device on the peer IPSec
router’s LAN or click Configuration > VPN > IPSec VPN > VPN Connection
and use the VPN connection screen’s Connect icon.
To Next Page
Loading...
