ZyXEL Communications ZyWALL USG 300 - Page 180

Chapter 7 Tutorials
ZyWALL USG 300 User’s Guide
180
3 Set the Device Role to Master. This example focuses on the connection from the
LAN (ge1) to the Internet through the ge2 interface, so select the ge1 and ge2
interfaces and click Activate. Enter a Synchronization Password
(“mySyncPassword” in this example) and click Apply.
Figure 147 Configuration > Device HA > Active-Passive Mode: Master ZyWALL
Example
4 Click the General tab. Turn on device HA and click Apply.
Figure 148 Configuration > Device HA > General: Master ZyWALL Example