ZyXEL Communications ZyWALL USG 300 - Page 717

Chapter 39 Device HA
ZyWALL USG 300 User’s Guide
717
1 Make sure the bridge interfaces of the master ZyWALL (A) and the backup
ZyWALL (B) are not connected.
2 Configure the bridge interface on the master ZyWALL, set the bridge interface as a
monitored interface, and activate device HA.
3 Configure the bridge interface on the backup ZyWALL, set the bridge interface as a
monitored interface, and activate device HA.
B
A
B
A
Br0 {ge4, ge5}
B
A
Br0 {ge4, ge5}
Br0 {ge4, ge5}