148
3 Click Configuration > VPN > L2TP VPN and then Create New Object > Address to create an
IP address pool for the L2TP VPN clients. This example uses L2TP_POOL with a range of
192.168.10.10 to 192.168.10.20. Click Create New Object > User/Group to create a user object
for the users allowed to use the tunnel. This example uses a user object named L2TP-test.
Enable the connection.
Set VPN Connection to Default_L2TP_VPN_Connection.
Set IP Address Pool to L2TP_POOL.
Select the authentication method (default in this example), and select the users that can use the
tunnel (L2TP-test in this example).
3.6.2 Configuring Policy Routing
You must also configure a policy route to let remote users access resources on the network behind the
USG.
• Set the policy route’s Source Address to the address object that you want to allow the remote
users to access (LAN_1SUBNET in this example).
• Set the Destination Address to the IP address pool that the USG assigns to the remote users
(L2TP_POOL in this example)).
• Set the next hop to be the VPN tunnel that you are using for L2TP VPN.
To Next Page
Loading...
