149
USG’s return traffic back through the L2TP VPN tunnel.
• Set Incoming to USG.
• Set Destination Address to the L2TP address pool.
• Set the next hop to be the VPN tunnel that you are using for L2TP.
If some of the traffic from the L2TP clients needs to go to the Internet, create a policy route to send
traffic from the L2TP tunnels out through a WAN trunk.
• Set Incoming to Tunnel and select your L2TP VPN connection.
• Set the Source Address to the L2TP address pool.
• Set the Next-Hop Type to Trunk and select the appropriate WAN trunk.
3.6.3
To configure L2TP VPN in an Android device, go to Menu > Settings > Wireless & networks >
VPN settings > Add VPN > Add L2TP/IPSec PSK VPN and configure as follows..
To Next Page
Loading...
