2N EasyGate Pro - Page 43

User Guide 2N® EasyGate PRO
43 / 87
   – Activation (1) – ID is not sent.
   – Suppression (2) – ID is always sent.
Default setting: According to provider

Minimum acceptable signal Function No.: 707 (SIM2-757)
On dual SIM gateway specify minimum acceptable signal. If current signal falls under this level,
gateway will switch to opposite SIM. Setting options: -103 dBm -97 dBm -91 dBm -85 dBm
Default setting: -103 dBm
Roaming enable/disable (Function No. 702)(SIM2-752)
You can make2N
®
EasyGate work even if it is registered to a foreign GSM network.
Setting options: – Disable (0) – The GSM module logs out of a foreign network and attempts to
register again in within 5 minutes.
   – Enable (1) –2N
®
EasyGate works in any GSM network.
Default setting: Disable

Call handover workaround (Function No. 703)(SIM2-753)
This parameter offers a workaround to prevent problems during call handover into the 1900
MHz (or 1800 MHz) band, caused by non-conforming configurations of the 1900 MHz (or 1800
MHz) GSM network.
Setting options: – Disable (0) – Disable workaround.
   – Enable (1) – Enable workaround.
   – Select only when handover into a 1800/1900 MHz band fails.
Default setting: Disable

APN setting Function No.: 706 (SIM2-756)
GPRS, UMTS, LTE or APN (Access Point Name) for automatic setting. The function number can be
used for SMS programming only (if available) Setting options: 0-40 characters Default setting:
blank

AMR enable (Function No. 704)(SIM2-754)
You can disable AMR (Adaptive Multi Rate) on the GSM module to improve voice quality in some
GSM networks.
Setting options: – Enable (1)