2N IP series Automation Manual

2N TELEKOMUNIKACE a.s., www.2n.cz 31/104
Delay
The block defines the event generated with a defined delay after another Delay
specified event. Define this event to delay the response to the other event by a
defined time interval (Delay).
Input parameters
Start – define the event that starts the delay.
Stop – define the event that stops the delay. The parameter is optional.
Delay – define the delay time. It is only possible to enter a numerical value, not a
value from an output parameter produced by other events.
Example of valid values:
10 – 10 seconds (units are unnecessary)
10s – 10 seconds
100ms – 100 milliseconds.
Output parameters
Event – the Event invoke connected Event or Action.
Example
Event generated 1s after the rise of event on row 1:

2N IP series Specifications

General

Category	Intercom System
Network Interface	10/100 Mbps Ethernet
Connectivity	Ethernet
Integration	SIP
Ingress Protection	IP54
Operating Voltage	12V DC
Audio Codec	G.711
Supported Protocols	SIP, RTSP, HTTP, HTTPS
Supported Languages	Multiple