StartMulticastSend
The block defines the starting action for audio stream sending to a StartMulticastSend
multicast IP address. You can control up to four independent transmission channels.
The RTP/UDP protocol is used.
Parameters
– define the event to launch this action.Event
– define the condition to be met for the action to be executed. This Condition
parameter is optional.
– define the channel number (0–3) to be controlled.Channel
– define the audio stream multicast IP address.Address
– define the UDP port to which audio stream shall be sent.Port
– define the audio source.Source
Valid values:
– the audio source is the microphone.mic
– the audio source is the call.call
The parameter is optional; the default value is .mic
– define the audio codec to be used.Codec
Valid values:
– codec G.711 u-lawpcmu
– codec G.711 A-lawpcma
– codec G.729g729
– codec G.722g722
– codec L16, 16 kHzl16
The parameter is optional; the default value is .pcmu
Example
Start audio stream sending via channel 1 to address 239.0.0.1:10000 if the event
defined on row 2 arises:
To Next Page
Loading...
Need help?
General
