2N IP series Automation Manual

2N TELEKOMUNIKACE a.s., www.2n.cz 69/104
SetOnvifVirtualInput
The block defines the sending action for a change of the virtual SetOnvifVirtualInput
input level via the ONVIF protocol. The ONVIF Device Manager (version 2.2.250) can
be used for the test.
Parameters
– define the event to launch the action.Event
– define the condition to be met to execute the action. This parameter Condition
is optional.
– define the virtual port ID.Port
Valid values:
– port ID0–10
– define the input level.Level
Valid values:
– set logical value to truehi
– set logical value to false.lo
The parameter is optional; the default value is hi (true).
Example
NVIF protocol if the Send information that port 8 has changed its value to 1 via the O
event defined on row 2 arises:
The following is sent to ONVIF:
InputToken: onvif_port_08
LogicalState:true

2N IP series Specifications

General

Category	Intercom System
Network Interface	10/100 Mbps Ethernet
Connectivity	Ethernet
Integration	SIP
Ingress Protection	IP54
Operating Voltage	12V DC
Audio Codec	G.711
Supported Protocols	SIP, RTSP, HTTP, HTTPS
Supported Languages	Multiple