SendWiegandCode
The block defines the action for sending of an entered code to SendWiegandCode
another device via the Wiegand interface.
Parameters
– define the event to launch the action.Event
– define the condition to be met to execute the action. This parameter Condition
is optional.
– define the code to be sent via the Wiegand interface. If the entered code Code
exceeds the capacity of the message transferred via the Wiegand interface, the
high-order bits are cut.
Valid values:
decimal number
– facility code. The setting applies only to "wiegand26".Facility code
Valid values:
decimal number in a range of 0 –255
The parameter is optional; if not set, then unused.
– define the format of the message sent via Wiegand.Format
Valid values:
– 26 bitswiegand26
– 32 bitswiegand32
– 37 bitswiegand37
The parameter is optional; the default value is .wiegand26
– define the module via which the code is to be sent.Module
Valid values:
module name configured in the Module name parameter in the
Hardware / Extenders / Modules / Wiegand module menu.
The parameter is mandatory for Verso but not applied for other models.
To Next Page
Loading...
Need help?
General
