2N IP series Automation Manual

2N TELEKOMUNIKACE a.s., www.2n.cz 82/104
FlipFlopD
The block is a one-bit memory cell (output parameter), which records the FlipFlopD
state of another condition at the moment of rise of the defined event for later use. The
FlipFlopD output can be used as a condition for action control in rather complex 2N
®
applications. It is a simulation of a D-type flip-flop circuit.Automation
Input parameters
Clock – define the event during which the current state of the condition is to be
recorded.
Condition – define the condition to be recorded at the rise of the ClockEvent.
ResetValue – set the condition default value upon restart. The parameter is
optional.
Valid values:
0 – condition is not met (default value)
1 – condition is met.
Output parameters
Out
Example
The state of the condition is same as the state of condition 2 at the rise of event 1:

2N IP series Specifications

General

Category	Intercom System
Network Interface	10/100 Mbps Ethernet
Connectivity	Ethernet
Integration	SIP
Ingress Protection	IP54
Operating Voltage	12V DC
Audio Codec	G.711
Supported Protocols	SIP, RTSP, HTTP, HTTPS
Supported Languages	Multiple