2N IP series - Page 22

Configuration manual for 2N IP intercoms
22 / 282
Tone Meaning
Default reset of network parameters
Upon power up, a 30 s timeout is set for the default reset code entering.
Refer to the Device Configuration subsection in the 2NIP intercom
Installation Manual for details.
Call end signalling
2NIP intercom enables the user to set a call end timeout to avoid call
blocking. Press a key on your VoIP phone to extend the call time during
this timeout. The purpose of the timeout setting is to avoid call blocking.
Connected VoIP phone
This short tone signals successful connection between a VoIP phone and
2NIP intercom.
•
Note
Signalling of some of the above mentioned statuses can be modified; refer to the
User Sounds subsection.
