Configuration manual for 2N IP intercoms
2. Express Wizard for Basic Settings
LAN Connection Setting
You have to know the intercom configuration interface address to connect to the LAN
successfully. Automatic IP address retrieval from the DHCP server is set by default in the2N IP
intercoms. Thus, if connected to a network in which a DHCP server configured to assign IP
addresses to all new devices is available, the intercom will obtain an IP address from the DHCP
server. The intercom IP address can be found in the DHCP server status (according to the MAC
address given on the production plate), or will be communicated to you by the intercom voice
function; refer to the Installation Manual of your intercom model.
If there is no DHCP server in your LAN, use the intercom buttons to set the static IP address
mode, refer to the Installation Manual of your intercom model. Your intercom address will then
be 192.168.1.100. Use it for the first login and then change it if necessary.
Now enter the intercom IP address into your favourite browser. We recommend you to use the
latest Chrome, Firefox or Internet Explorer 9+ versions2N IP intercom is not fully compatible
with earlier browser versions.
Use the name admin and password 2n (i.e. default reset password) for your first login to the
configuration interface.
The intercom requires a password change upon the first login. Strong passwords are only
accepted - eight characters at least including one capital letter, one small letter and one digit.
Remember the new password well or put it down just in case. Because if you forget the
password, you will have to reset the intercom to default values (refer to the Installation Manual
of your intercom model) and lose all your current configuration changes.
•
Tip
FAQ : IP address - How to get IP address from 2N IP Intercom?
To Next Page
Loading...
Need help?
General
