2N IP series - Page 231

Configuration manual for 2N IP intercoms
231 / 282
•
•
•
•
Bluetooth & 125 kHz, 13.56 MHzRFID Reader Configuration / 2N IP Style

13.56 MHz (125 kHz) Card Reader (serial number)
Module Name– set the module name for card reader logging purposes.
Door–set the reader direction (Arrival, Departure) for the Attendance system purposes.
Associated Switch–set the switch to be activated after user authentication via this
module. If you set Door Lock Switch, the authentication rules specified in Hardware / Door
will be used.
Allowed Card Types– set the type of a card to be accepted by the card reader. The card
reader supports just one card type at an instant.