2N IP series - Page 239

Configuration manual for 2N IP intercoms
239 / 282
5.6.1 Network
As the2N IPintercom is connected to the LAN, make sure that its IP address has been set
correctly or obtained from the LAN DHCP server. Configure the IP address and DHCP in
theNetworksubsection.
If you use the RADIUS server and 802.1x-based verification of connected equipment, you can
make the intercom use theEAP-MD5 or EAP-TLS authentication. Set this function in
the802.1xtab.
•
Tip
To know the current IP address of your intercom, use the 2N
®
Network Scanner,
which can be freely downloaded from www.2n.com, or apply the steps described in
the Installation Manual of the respective intercom: the intercom communicates its IP
address to you via a voice function.
